Turn the key over, from this picture, and see if it has an "S", "P", or something similar at the top of the key blade there, below by the black plastic part. If you have one of the big fat, thick plastic key heads with an off center hole you will have the transponder in it then. You will also notice a small black square on the topside, this is The Snap-on software has the capability to do that for the Ford PATs keys so let's go through that on the SOLUS Edge. We're all plugged in here so let's just go into the Scanner and it is a Ford, so we'll do a quick auto ID. It comes up as a 2007 Taurus with a three-litre engine. And then we'll go down to the Anti-Theft PAT System. Step 1 – Turn ignition to "ON". Insert the key into your ignition, and turn it to the ON position, but don't start the car. Wait a few seconds until the lights on the dash go away. Figure 1. Turn key to "ON" position. How do I bypass Immobiliser on Ford Fiesta? Enter the key into the door lock of the driver's side. By turning the key once, you can open the door, but not with it completely open. 40-60 seconds should be enough for this key position to be fully exercised. This will show what the immobilizer thinks is the problem. Also, check all the fuses and relays in both fuse boxes, one in the engine compartment and one just past the bottom of the glovebox under the cover above the passenger's feet area. If it's only the key that's not programmed you can do that yourself in a few seconds if you have at least The engine immobiliser/smart lock light came on, not sure why since only the correct key was ever used. We have checked all the basics, fuses, battery, the steps in the manual (Gregorys), but no luck. I have tried all the suggestions my google fu as found including: disconnected the battery, left the key in the "on" position for both 30 and 61 In this Video I explain how to reset the Anti-Theft System on Fourth Generation Ford Mustang.About Us : http://www.howstuffinmycarworks.com Remove the key from the door, get into your Ford, and start the engine. The system should be reset. Insert the key into the driver's side door lock. Turn the key once, but not all the way to unlock the door. Leave the key in this position for 40-60 seconds. Do this again, but turn the key in the opposite direction. Vay Tiền Online Chuyển Khoản Ngay.

how do i reset my ford immobiliser